|
|
Build Your Online Product Catalogs?
| Product Name: |
Circuit board to take off the tin electronics equipment
|
| Supply Ability: |
10 set |
| Related proudcts |
circuit board, |
| Specifications |
only need to 1-2 people, reducing the consumption of human resou |
| Price Term: |
TT |
| Port of loading: |
tianjin |
| Minimum Order |
1 |
| Unit Price: |
6000 |
|
Circuit board to take off the tin electronics equipment
With electronic components of the circuit board by conveyor to close the wind into the feeding roller and feed preheating chamber.
1, close your wind feeding roller: to prevent the cold air from there into the machine. Closed wind feeding roller conveyor feeding devices below. Conveyor belt and closed wind under linear velocity, feeding roller diameter to evenly into the material.
2, feed preheating warehouse: inlet is equipped with double heat shield to prevent heat leak, into the waste circuit board through the machine here to waste heat by more than 200 degrees, the preheating temperature and exhaust of the material. After cooling discharge of waste gas from the warehouse top of negative pressure suction, and through the other exhaust gas treatment equipment for processing. Material after preheating through lateral vibration feeding, material into the heating roller to remove waste tin electronic components.
Material separation drum sieve into the heating, the heating separation drum screen for large middle heater, drum sieve sieve plate can change according to the requirements of different aperture sieve plate. The separation of the outer edge of the drum screen has double insulation cotton, heat preservation and collection of circular cylinder off tin and electronic components, intermediate heating rod put the stainless steel roller heated to above 300 degrees, because the melting point of tin alloy at 220 degrees, the material into the heating roller and melted the tin in the drum tilt Angle and the rotation speed can be adjusted according to the material, the tin and tin shaker, the electronic components to the point. Material from the left to enter, the right side of the discharge, the discharge speed can be adjusted through the rolling speed and Angle. While most of the material in the back of tin and electronic components, drop through friction to make electronic components and pipeline by dropping it on a tin of vibrating screen,
Circuit boar |
| Company: |
Henan Jufeng ECO technology Co., LTD
|
| Contact: |
Mr. feng ju |
| Address: |
No.4 courtyard ,zhengsan street,zhengzhou city,henan province,China |
| Postcode: |
450000 |
| Tel: |
0371-65950998 |
| Fax: |
0371-65950998 |
| E-mail: |
|
|
|
|
Home
